Double-check your work; you must ensure the side of the SCSI
cable with the red stripe is matched to Pin 1 on the interface
board and on the drive.
The easiest way to install your SCSI cable is to plug it into the SCSI connector
on the rear panel of the drive before you insert the drive into your computer.
Then you can thread the cable through the front of the open bay you plan to
use and back toward the SCSI interface board. Connect the cable to your SCSI
interface board and finish mounting your drive in the proper position. The
drive should slide smoothly into the bay. If it does not, check for obstructions
in the bay and ensure the side rails (if needed) are attached properly.
You now need to make the power connection. In most computers, you will
find additional power connectors that are ready for your use. Check the cable
running from your power supply to your hard disk and see if it has extra
connectors on it. If so, you can plug one of these into the power connector
found on the rear panel of the CD-ROM drive.
If you do not find any additional connectors available (either because they
were not supplied or they are all in use), you will have to buy a “splitter” or a
“Y-connector.” These can also be found at most computer stores. If you are in
32
ULTRAPLEX 40X OPERATION MANUAL
CHAPTER 8 — Hardware Installation
To Pin #1
Either end of the cable may be connected
to the CD-ROM drive or the SCSI
interface board
Pin #1
#1
Summary of Contents for PX-40TSe
Page 93: ......
