If you must use mounting rails, install them as shown below:
There are four holes provided on each side of the drive. To mount an internal
drive in most computers, the rails should be fastened to the lower pair of holes.
In some instances, you may need to fasten the rails to the upper set of holes.
You will find that four screws were supplied with your drive. Use only these
screws to attach the mounting rails. Using screws other than those supplied by
Plextor could damage the drive or strip the threads.
Check the positioning of the rails by sliding the drive into the bay before you
connect any cables.
Check Your Jumper Settings
Once you have a) mounted the rails; or b) determined that you don’t have to
use mounting rails, you are almost ready to finish your drive’s installation.
However, before doing so, check your jumper settings one last time and be
sure to record the serial number of your drive for future reference. It may also
be helpful to record the “TLA” code found on the back or top of your drive.
If you do not have any SCSI peripherals (e.g., hard disk, scanner, printer, etc.)
in your system other than your CD-ROM drive, you should not change the
jumpers from their factory setting or change termination.
If you do have other SCSI peripherals as part of your computer system, you
may need to change the settings of the SCSI ID and/or reset the termination.
See Chapters 6 and 7 for information on how to change these settings.
30
ULTRAPLEX 40X OPERATION MANUAL
CHAPTER 8 — Hardware Installation
Be sure not to mistake the inner and outer
face of a rail when attaching.
Typically, the smooth side of the
rail faces away from the
drive’s chassis.
Summary of Contents for PX-40TSe
Page 93: ......
