ULTRAPLEX 40X OPERATION MANUAL
83
these lines by marking them as Remarks. Select Save from the File menu, and
then Exit.
Reboot Your Computer
Reboot your machine by selecting Shut Down from the Start button. Select
Restart the computer and select Yes. This will reboot your computer with the
new configuration.
When Windows 95/98 starts, an icon for a CD-ROM drive will appear in My
Computer. If it does not, then the support for your SCSI controller has probably
not loaded correctly. Go to the following section titled Add New Hardware.
Even if you get the CD-ROM icon, you may want to check that the Windows
95/98 32-bit driver is working properly. Select Control Panel in My Computer
and double-click on System. Click on the tab called Device Manager at the top
of the window. In the new window of devices, double-click on SCSI
Controllers. This displays all the SCSI controllers currently installed in your
system. In the box called Driver Status the message should be This Device Is
Working Properly. If you get this message, you can now make full use of your
CD-ROM drive with the Windows 95/98 32-bit support.
Add New Hardware
If your SCSI controller is not recognized by Windows 95/98 after installation,
or if the message under Driver Status does not indicate that it is working prop-
erly, you can use the Windows 95/98 Add Hardware Wizard in an attempt to
load the required support. Access My Computer, open Control Panel, then
double-click on the “Add New Hardware” icon and follow the directions. This
will look for and auto-install Windows 95/98 support for your SCSI board and
CD-ROM drive if available. At the end of this process, a screen will notify you
if the SCSI board has been detected. If no new devices are detected, your SCSI
board is probably not supported by Windows 95/98 directly. You may be able
to get support from the manufacturer of the SCSI controller by calling their
technical support department.
APPENDIX — Windows 95/98 Installation Guide
Summary of Contents for PX-40TSe
Page 93: ......
