Platinum Curve Stairlift, Installation Manual, Page: 38 / 44

38
Engineers Menu
Further diagnostics and settings are available by cycling through the menu
system.
Code
Meaning
Position 12345 Lifts current position on rail. Bottom end stop is 00000. Press and hold menu
button to reprogram.
Remote 1/2/3/4 Shows current Remote channel selection. Press adjust button to change.
Right/Left Hand Shows current installation hand selected. Press adjust button to change.
Quiet Travel /
Travel Alarm
Shows current travel alarm selection. Press adjust button to change.
Landing Stop /
Pass
Shows current landing selection. Press adjust button to change.
Powered / Manual
Swivel
Shows current swivel selection. Press adjust button to change.
Edge 123
Number of sensitive edge trips since last engineer reset. Press adjust button to
reset to 0.
Low Batt 123 Number of low battery events since last engineer reset. Press adjust button to
reset to 0.
Trips 12345 Number of trips (up or down) done by control system. Not resettable.
Safety 123 Number of safety circuit trips since last engineer reset. Press adjust button to
reset to 0.
Brake 123 Number of brake faults since last engineer reset. Press adjust button to reset
to 0.
Relay 123 Number of relay faults since last engineer reset. Press adjust button to reset to
0.
LostP Number of times position has been lost since last engineer reset. Press adjust
button to reset to 0.
Battery Bar (bar
display 1-8)
A bar display of battery voltage. Approx. 21V (all off) to 27V (all on).
Low Battery Battery below 21V
Mains Power, Battery Power and Power Cuts
The DC charger supplies power to a set of large internal batteries. These
batteries then power the motor which lifts the chair up and down the stairs.
If the mains power fails, you can continue to use the stairlift for a short while
as the batteries store enough power to allow you up and down the stairs a
few times.