Platinum Curve Stairlift, Installation Manual, Page: 24 / 44

24

Important:
You will be running the stairlift with some of the internal electrical
connections accessible. Take care when running in this mode.
To Program the lift:
If the PCB side plastic cover
is not already removed, undo
the two 7mm nuts and plastic
washers located at the
bottom of the cover. The
cover can then be removed
taking care not to damage the
locating lugs at the top.
Bring the lift to the bottom
stop/charge point, and ensure
the lift is correctly on charge.
The diagnostic display should
read “Platinum”.
.
There are 2 red momentary
buttons located on the PCB.
The button on the right,
Menu
Switch , cycles through the
various memory options, the
button on the left,
adjust
Switch , changes the chosen
option.
The first operation is to set
the hand of the lift. This is
defined by the side of the
staircase that the rail is fitted
to when viewed from the
bottom.
Press the menu button twice
until either “
Left Hand
” or
“
Right Hand
” is displayed.
Press the adust button to
change the selection.
If the powered swivel option
is fitted, the next menu option
sets the swivel type. Cycle
throught the menu until either
“
Manual
” or “
Powered
Swivel
” is displayed using the
menu button, and adjust
selection using adjust button.
If an intermediate charge point is fitted, and is to be used as an entry/exit
point for the user, cycle throught the menu and adjust “
Landing Pass
” to
“
Landing Stop
”. If an unladen travel audiable warning is required, cycle
throught the menu and adjust
“
Quiet Travel
” to “
Travel Alarm
”.