Platinum Curve Stairlift, Installation Manual, Page: 25 / 44

25
The diagnostic display will
time out after approx. 8
seconds back to it’s normal
state
, displaying “Platinum”.
Press and hold the menu
button for 4 seconds until the
display changes to “Program
0000”. You will notice a small
S in the bottom right hand
corner of the display. This
indicates that the first section
to be programmed is a slow,
half speed section. The 0000
indicates that you are at the
bottom of the track. Move the
lift upwards approx. 250mm
and stop. The number
displayed will increase.
Press the adjust button once,
and the
S will be replace with
an F . This indicates that the
next section to be
programmed is a fast, full
speed section.
If there are any tight radius, internal bends, the lift needs to travel at half
speed around these. Use the adjust button to switch between
F ull and S low
speed for every internal bend.
If the rail configuration includes a parking wrap at the bottom, it is usually
better to keep the lift at half speed from the bottom of the track until after
the internal bend.
If an intermediate parking point is going to be used for the customer to get
on/off the lift on intervening floors, the lift should be slowed to half speed
250mm before the charge point and can be returned to full speed 250mm
after.
Continue until the lift comes to the end of the rail, ensuring that you
program the lift to slow at least 250mm before it comes to rest against the
top stop.
The lift will recognise that it has reached the top and exit programming
mode. The display will revert to “Platinum” and the carriage will travel
according to the program