the existing mains voltage. Incorrect mains voltage can destroy the
milling unit and its components.
5. In order to avoid an electric shock, do not insert objects in the milling
unit; the only exception is the intended replacement of parts in
accordance with this user’s manual.
6. In order to perform maintenance work always first disconnect the milling
unit from the mains power supply and wait for a few minutes before
starting work.
7. Never operate the milling unit from locations in which there is a risk that
water or other liquids might penetrate the device or the control.
8. The surface upon which the milling unit is installed must be sufficiently
stable. Observe the permissible load capacity and have this checked by
a structural engineer if necessary.
9. Opening the milling unit housing and repairing the milling unit must be
performed by an authorised Planmeca service technician exclusively.
10. Note that there is a risk of injury when a milling cutter is clamped in the
milling spindle.
This can lead to serious injuries and even death.
11. The milling milling unit may only be operated with original Planmeca
accessories or accessories that have been approved by Planmeca.
When replacing parts in accordance with this user’s manual, it is
essential to use original Planmeca parts. No liability shall be accepted for
damage that results from the use of accessories or external parts that
have not been approved.
12. Do not use the milling system in areas at risk of explosion.
13. Avoid tripping hazards and damage to the lines when laying network
lines, data lines and the pneumatic hose.
14. If a change to the milling milling unit or components is made without the
written permission of Planmeca then the issued EC declaration of
conformity is voided and we exclude any liability for injuries or damages
to the milling unit that arise as a result of this.
15. Clean the milling unit using suitable cleaning products only.
16. When cleaning the milling unit avoid inhaling any dust or gases that arise
(wear respiratory protection).
17. Mobile phones should not be used in close proximity to the milling unit to
avoid interference with the unit.
4.11 Personnel requirements
The tasks described in this user’s manual place different requirements on
the qualifications of the persons entrusted with these tasks.
WARNING
With insufficient qualification of personnel! Insufficiently qualified personnel
are unable to correctly assess risks posed when working with the milling unit.
These persons may therefore put themselves and others at risk of serious
and even fatal injuries. In order to avoid this, all work must be carried out by
appropriately qualified personnel exclusively. Persons whose reactions are
impaired, for instance through drugs, alcohol, or medication, are not
permitted to perform any work on the milling unit.
4 For your safety
User's manual
Planmeca PlanMill 50 S 17
