1 Introduction
Planmeca PlanMill 50 S is a milling unit intended for manufacturing of dental
prostheses. This manual describes how to operate the Planmeca PlanMill 50
S milling unit.
NOTE
Read these instructions carefully before connecting or operating the unit and
keep the instructions in the immediate vicinity of the unit and available at all
times to persons operating the unit.
The smooth function and operational safety can only be guaranteed if the
general safety precautions and the specific safety information provided in
these instructions are observed when operating the unit.
The unit may only be operated in a technically flawless and reliable
condition. Improper handling and use could cause danger to the users and
damage the unit.
1.1 Information regarding this manual
NOTE
Read this user’s manual through carefully before connecting and starting up
the milling unit! As with all technical systems, it is only possible to guarantee
the faultless functionality and operational safety of this milling unit if the
generally applicable safety precautions and the special safety instructions in
this user’s manual are observed during its operation. Every person involved
with the installation, operation, maintenance, repair and inspection of the
system must have read and understood the following safety instructions!
This user’s manual must be kept throughout the entire service life of the
milling unit. It must be freely accessible at all times and must be located in
the immediate vicinity of the milling unit.
Despite every effort, it is not possible to fully exclude printing errors and
mistakes. We welcome any suggestions for improvements and information
regarding errors.
The information provided in this manual is based on a standard scope of
supply, with which the milling unit is operational.
Milling units from Planmeca are CE compliant and labelled accordingly. For
all other milling unit parts and components, for which the CE safety
guidelines are applicable, start- up is prohibited until all corresponding
requirements have been fulfilled. If a change is made to the system without
agreement with the manufacturer (Planmeca), CE conformity is invalidated.
As soon as such changes are made to the milling unit, Planmeca accepts no
liability whatsoever.
The ECM test only applies to the milling unit in its original configuration ex
works.
The following documentation complies with the valid legal provisions,
regulations and ordinances, as well as standard engineering practice at the
time the milling unit was delivered.
NOTE
Before using the milling unit, it is essential to read this user’s manual
carefully!
1 Introduction
User's manual
Planmeca PlanMill 50 S 1
