CAUTION
If this equipment is used in a manner not specified by the manufacturer, the
protection provided by the equipment may be impaired.
Read all instructions in this manual before using this extractor.
WARNING
Mains voltage. Dangerous voltages exist in this equipment. Ensure all
covers are fitted before operating this equipment.
The unit is now ready for use.
A.3 Operation
A.3.1 Manual operation
The extraction unit is turned off and on by means of an illuminated rocker
switch on the front of the unit.
Filter condition signal – indicators and component controls
The LED on the front panel (see above Fig) indicate when the filter is
blocked.
The right switch will allow the vacuum motor to be either On/Off/Auto. Auto
will require a voltage input to the interface connector on the rear of the unit.
(see Fig 3)
A.4 Maintenance
User maintenance is limited to cleaning the unit and replacing the filters with
new. Only Planmeca trained maintenance technicians are authorised to
carry out component testing and replacement. Unauthorised work or the use
of unauthorised replacement filters may result in a potentially dangerous
situation and/or damage to the extractor unit, and will invalidate the
manufacturer’s warranty.
A.4.1 Cleaning unit
The powder coated finish can be cleaned with a damp cloth and non
aggressive detergent. Do not use an abrasive cleaning product as this will
damage the finish.
The cooling inlets and outlets should be cleaned once a year to prevent build
up of dust and overheating of unit.
Appendix A: Suction unit (optional)
120 Planmeca PlanMill 50 S
User's manual
