7.2.1.1 General cleanliness and handling
The adapter has to be calibrated in Planmeca PlanMill 50 S milling units
before the first use to ensure an optimal positioning of the DESS system.
Therefore the following aspects must be considered:
•
Cleanliness of the blank adapter (milling unit) and of the DESS adapter
•
General Cleanliness
•
No damages in the bearing surface
•
The milling unit and its zero-point must be set correctly
•
Always clamp the adapter in the same position
•
Screw connections
•
The 6 screws should always be tightened in the same order for a
reproducible positioning
•
Only screw the 6 countersunk screws loosely at first
•
Afterwards tighten the screws crosswise (always in the same
order)
7.2.1.2 Preparing adapter for test milling
NOTE
Please follow directions on general cleanliness and handling.
•
The two test pins, available from your local premilled blank supplier, are
thoroughly inserted into the middle positions (2 + 5), pushed in to the
limit, and firmly clamped with the clamping screw by using a torque
wrench.
•
The DESS adapter is then fixed into the clean milling unit reception. The
screws should always be screwed in loosely at first and tightened
afterwards in the same order, 1 - 6.
•
The test pins are milled directly on the milling unit with the scripted test
program available from your local dealer. A 2mm metal tool (T2) is
required for the milling process.
7 Adapters
User's manual
Planmeca PlanMill 50 S 35
