Copyright Planika Sp. z o.o.
www.planikafires.com
IG0033#08
2020-03-20
7
•
Corrosion of the coating of the base of GaLiO Corten is a natural process resulting from the characteristics of
the Corten steel which the fireplace is made of. It is an additional protective layer of the appliance against the
negative influence of unfavorable weather conditions.
•
Other parts of the GaLiO Corten fireplace are made of stain resistant material.
•
Never leave a turned on GaLiO Corten without supervision.
•
The GaLiO Corten fireplace needs to be installed in a place inaccessible for children, unauthorised persons or
animals for the direct contact with the flame or hot parts of the device to be impossible.
•
In case of heavy wind the GaLiO Corten fireplace needs to be immediately turned off and one needs to await
until the heavy wind passes.
•
In case of noticing any sort of gas leaks the fireplace as well as the main valve of the gas cylinder need to be
turned off.
•
After use turn off the gas cylinder valve.
2.1
Safety instruction regarding the use of the gas cylinders.
•
Use only the type of gas and pressure specified by the manufacturer.
•
The gas cylinders should always be placed in a vertical position – during use and transport.
•
Always store the gas cylinder in an easily accessible place to allow its immediate turn-off.
•
During the installation process do not allow an open flame or any ignited object to reach the gas cylinder.
•
The gas cylinder must be located in accordance with AS/NZS 5601 and AS/NZS 1596.
•
Leaks should be found with the use of a cleaning liquid and water. If bubbles form on the surface that means
that there’s a leak that must be fixed before operation.
•
Use only approved and certified hose and regulator assemblies, check condition before each use and replace
every 2 years.
•
Ensure any hoses are kept away from sharp edges and hot surfaces. Refrain from bends and twists over its full
length.
•
Remember that the LPG bottle should be stored in a well-ventilated place. LPG gas is heavier than air and its
accumulation near the bottom surface may generate an explosive mixture.
•
The housing in which the LPG bottle is (optionally) placed needs to have an appropriate ventilation. The
housing needs to have upper and lower ventilation (minimum 200cm
2
each, in accordance with AS/NZS
5601.1).
•
The gas cylinder needs to be shut if the fireplace is not being used.
•
Filling the gas cylinders is to be commissioned to certified gas filling stations.
•
Replacement of empty cylinders for full ones is to be conducted only in authorised locations.
3.
INSTALLATION
3.1.
Box contents
