Copyright Planika Sp. z o.o.
www.planikafires.com
IG0033#08
2020-03-20
8
•
1x complete Galio Corten gas fireplace
•
1x remote control
•
4x Tempered glass guards
•
1x Touch panel (installed)
•
4x AA Batteries
•
2x AAA Batteries
•
4x bag of decorative stones
•
1x AS/NZS 1869 hose assembly – installed (only LPG version)
•
1x pressure regulator– installed (only LPG version)
•
1x installation manual and user’s manual
3.2.
Unboxing and installation
•
The contents of the boxes need to be carefully unwrapped from the foam foil.
•
Remove the bags with decorative stones from the burner reservoir and place them away from it.
•
Remove the Styrofoam placed on the unit.
•
Carefully lift the appliance and pull out the glass shield wrapped in cardboard from the inside of the GaLiO
Corten.
•
Check the completeness of the elements with the contents list.
•
Make sure that the device nor its elements weren’t damaged during the transportation (if they were, notify
the supplier).
•
Place GaLiO Corten on a flat, paved surface outside of the building, preferably on the place of final installation.
Leave sufficient space on the side of the appliance where control panel is located (minimum 1 m).
•
The decorative stones are to be scattered evenly around the reservoir to completely cover the burner of the
fireplace.
•
WARNING!!!
The stones may not cover or be placed inside the device protecting the ignition unit (Photo 1).
•
It is forbidden to place any other decorative stones which are not supplied by the manufacturer.
•
Delivered stones (Silicon Carbide – SiC, content 85%-95%).
Photo 1
•
Carefully install the primary glass guards (See point 3.3).
•
In the case of GaLiO Corten powered with natural gas, to obtain the optimum image of the flame, cover the
burner with a single layer of decorative stones leaving some spaces uncovered of approximately every 10 cm
(Photo 2).
