07
GEO:CS1
FIG-1
A
Ensure the marker is switched Off before you begin.
B
Attach both ends of the barrel together.
Screw the barrel tip counter-clockwise into the barrel back.
C
Attach the complete
barrel to the marker.
Screw the barrel clockwise into the marker body.
D
Fit a
barrel blocking device for safety.
E
Ensure the marker is de-gassed.
Push in and hold the
POPS button and pull the POPS bonnet away
from the
POPS body.
F
Attach the pre-set
air system.
Screw the air system clockwise into the
POPS body.
G
Loosen the
clamping feed neck.
Open the
feed neck lever away from the feed neck.
Unscrew the feed neck lever screw counter-clockwise.
H
Attach the loader.
If the feed neck is too tight, loosen the clamping feed neck more.
I
Secure the loader.
Screw the feed neck lever screw clockwise to tighten.
Close the feed neck lever to secure.
J
Gas the marker.
Pull the
POPS bonnet backwards until it engages.
K
Switch On the CS1.
1
IMPORTANT!
To switch Off/On, see page 08.
2
DO NOT
over-tighten the barrel.
3
IMPORTANT!
Ensure the marker is de-gassed when setting up.
4
NEVER
use CO2. Compressed air or Nitrogen only.
5
DO NOT
over-tighten the feed neck. This may damage the CS1 or
the loader.
6
DO NOT
use a preset regulator that outputs over 650 psi.
QUICK START
SETTING UP THE CS1
WARNING!
Always make sure the marker is Off with a
barrel blocking device installed and
that no paintballs are in the CS1 or loader before installing an air system.
Compressed air and nitrogen systems can be extremely dangerous if handled
or used incorrectly.
Only attach an air system certified for use within the country of use.
Never add lubricants or grease into the fill adaptor of the
air system regulator.
Ensure that all screws are tightened and no parts are loose before installing an
air system.
Do not pressurise the CS1 without the bolt system correctly installed, as high
pressure gas will be emitted.
Do not install a compressed air system or load paintballs into the CS1 until you
feel confident with your ability to handle the marker safely and responsibly.
WARNING
Summary of Contents for GEO CS1
Page 1: ...01 GEO CS1 PLANET ECLIPSE GEO CS1 USER MANUAL ENGLISH 68 CAL ...
Page 5: ...05 GEO CS1 ...
Page 6: ...FIG 1 06 GEO CS1 QUICK START SETTING UP THE CS1 F C B E D H I K J A G HEX 5 32 1 2 2 5 3 4 6 ...
Page 14: ...FIG 1 14 GEO CS1 QUICK START UNLOADING THE CS1 D G H C A F B E HEX 5 32 2 1 6 5 3 4 ...