FIG-2
FIG-1
FIG-3
24
GEO:CS1
ELECTRONICS
USER INTERFACE PARAMETERS
FIG-1 - RAMP SET-UP MENU
This menu is only available when ramping has been chosen from the FIRE MODE menu.
FIG-2 - TYPE PARAMETER
Select the type of ramping based on the options below:
>
STEP: The CS1 will be fired in semi-automatic until a number of
trigger pulls (set by
SEMI
SHOTS) have been made at a minimum pull
rate (set by
KICK IN). The CS1 will then STEP up
to the maximum
rate of fire (set by BS ON ROF). Ramping is maintained as long as the user
continues to pull the trigger at a required rate (set by
SUSTAIN).
>
LINEAR: The CS1 will be fired in semi-automatic until a number of
trigger pulls (set by
SEMI
SHOTS) have been made at a minimum pull
rate (set by
KICK IN). The rate of fire will then
equal the rate of
trigger pulls increased by a percentage (specified by RATE) up to a maximum
rate of fire (set by BS ON ROF). Ramping is maintained as long as the user continues to pull
the trigger at a required rate (set by
SUSTAIN).
> CANCEL: Editing is cancelled and no changes are made to the parameter.
FIG-3 - RATE PARAMETER
Only available in LINEAR ramping mode. This sets the percentage increase in rate of fire over
rate
of trigger pulls.
If the RATE is 50% and the
trigger is pulled at 10 bps then the
ROF is 15 bps (10 + 50%).
This parameter can be set between 0 and 100% in 10% increments.
Summary of Contents for GEO CS1
Page 1: ...01 GEO CS1 PLANET ECLIPSE GEO CS1 USER MANUAL ENGLISH 68 CAL ...
Page 5: ...05 GEO CS1 ...
Page 6: ...FIG 1 06 GEO CS1 QUICK START SETTING UP THE CS1 F C B E D H I K J A G HEX 5 32 1 2 2 5 3 4 6 ...
Page 14: ...FIG 1 14 GEO CS1 QUICK START UNLOADING THE CS1 D G H C A F B E HEX 5 32 2 1 6 5 3 4 ...