INSTALLATION
INSTALLATION
21
FITTING THE FRAME
(cont)
Place the breech sensor into its hole
in the marker body
(Figure 2.12)
and
check that the exposed cable is not
too long. If it is too long then draw
some of the cable back through the
frame by gently pulling the back of
the wire.
Bring the frame up to the bottom of
the marker, and attach using the two
10-32 UNF x
1
/
2
” Stainless button
head screws.
(Figures 2.10 and 2.11)
Ensure that no wires are trapped
between the top of the grip frame and
the bottom of the marker body. Do not
tighten the screws.
Plug the breech sensor cable into the
relevant socket on the printed circuit
board. This connector is polarised and
will only fit one way round.
(Figure 2.13).
Figure 2.10
Figure 2.11
Summary of Contents for Eclipseblade E2
