45
ADVANCED SET-UP
ADVANCED SET-UP
There are three adjustment points on
the trigger - the
Front Stop Trigger Screw
,
the
Rear Stop Trigger Screw
and the
Return
Strength Trigger Screw
.
As standard each Eclipseblade E2
frame comes with a factory-set trigger
travel of approximately 2mm in total
length: one millimetre of travel before
the firing point, and one millimetre of
travel after the firing point.
Setting the Trigger
The
Front Stop Trigger Screw
is used to
set the amount of trigger travel prior
to the marker firing. Turn this screw
clockwise to reduce the amount of
travel. Do not turn the screw too far
or the trigger will be pushed past its
firing point and the marker will not fire.
Turn this screw counter clockwise to
increase the amount of trigger travel
(see figure 5.1)
.
Figure 5.1
The
Rear Stop Trigger Screw
is used to
set the amount of trigger travel after
the marker has fired. Turn this screw
clockwise to reduce the amount of
travel. Do not turn the screw too far
or the trigger will be prevented from
reaching its firing point and the marker
will not fire. Turn this screw counter
clockwise to increase the amount of
trigger travel
(see figure 5.2)
.
Summary of Contents for Eclipseblade E2
