ORIENTATION
ORIENTATION
25. Printed Circuit Board
The PCB contains all of the electronics required to control
the operation of the Eclipseblade E2 electronic grip frame.
26. Cocking Solenoid Connector
This connector is used to connect the cocking solenoid
wires to the printed circuit board.
27. Sear Solenoid Connector
This connector is used to connect the sear solenoid wires
to the printed circuit board.
28. Breech Sensor Connector
This connector is used to connect the breech sensor cable
to the printed circuit board.
29. Programmer Connector
This connector is used to connect the frame to a
computer using the Eclipseblade E2 Programmer Kit
(available separately).
20. Sear Solenoid Retainer
The retainer prevents the sear solenoid from lifting out of
the frame and also sets the height of the sear correctly.
21. Sear Solenoid.
This solenoid is used to control the fi ring mechanism of the
marker, by moving the Sear when activated. Two electrical
wires connect the Sear Solenoid to the Printed Circuit board.
22. Trigger Pin.
This pins passes through the top of the trigger and is held
in place by a small set screw.
23. Set-up Push Button
This push button is used to access the set-up menu.
24. Battery
The battery provides the power for the electronics. The
battery terminals are pushed against two spring connectors
on the circuit board. A groove is machined into the frame
below the battery to assist with battery removal.
12
Summary of Contents for Eclipseblade E2
