IMPORTANT SAFEGUARDS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
When using electrical equipment, basic safety precautions should always be followed including the following:
•
CAUTION: Do not join converter connector until installation is complete and AC Power is supplied to
the emergency driver,
• This product is for use with an emergency LED lighting load and supplies a maximum of 7W, 10W or 21W of
power and a maximum voltage of 48VDC in emergency mode for a minimum of 90 minutes.
• To reduce the risk of electric shock, disconnect both normal and emergency power supplies and converter
connector of the emergency driver before servicing.
• This emergency driver is suitable for both factory and field installation.
• This product is suitable for use in dry and damp locations.
• The ambient temperature for use is 0°C to 50°C (32°F to 122°F).
• Do not install outdoors.
• An unswitched AC power source of 120/277VAC, 60Hz is required.
• Do not install near gas or electric heaters.
• Do not attempt to service the battery. A sealed, no
‐
maintenance battery is used that is not field replaceable.
Contact the manufacturer for information on service.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Install in accordance with the National Electrical Code or Canadian Electrical Code and any local regulations.
• Do not use this product for other than intended use.
• Servicing should be performed by qualified service personnel.
• Equipment should be mounted in locations and at heights where it will not be subjected to tampering by
unauthorized personnel.
• For use with a metal grounded enclosed wiring system or equivalent.
SAVE THESE INSTRUCTIONS!
Technical Support
■ (623) 580-8943 ■ [email protected]
LEMD Series
Installation Instructions
10070337 P
1 - 11/23
1
800-533-3948 www.barronltg.com
