32
Output
(n.c. start)
Normally closed, active at start
(n.o. threshold)
Normally open, active on reaching
alarm
5
(n.c. threshold)
Normally closed, active on reaching
alarm
5
33
Alarm 2
Reset
Type of Reset for contact
of alarm 2
(Automatic Reset)
Default
(Manual Reset)
(Manual Reset Stored)
34
Alarm 2 State
Error
State of contact for alarm
2 output in case of error
Default
35
Alarm 2 Led
State of OUT2 led
corresponding to relative
contact
Default
36
Alarm 2
Hysteresis
Alarm 2 hysteresis
-999…+999 digit
∗
(tenths of degree if temperature).
Default: 0.
37
Alarm 2 Delay
Alarm 2 delay
-180…+180 Seconds
Negative: delay in alarm output
phase.
Positive: delay in alarm entry phase.
Default: 0.
38
Alarm 2
Setpoint
Protection
Alarm 2 set protection.
Does not allow operator
to change value set
Default
47
Amperometric
Transformer
Activation and scale
range of amperometric
transformer
0 Disabled
1-200 Ampere
Default: 0.
48
Loop Break
Intervention threshold of
Loop break alarm
0.0-200.0 Ampere
Default: 50.0.
5
On activation, the output is inhibited if the controller is in alarm mode. Activates only
if alarm condition reappers, after that it was restored.
∗
The display of the decimal point depends on the setting of parameter
and parameter
