16
Updating Memory Card
To update the memory card values, follow the procedure described in
the first method, setting display 2 to
so as not to load the
parameters on controller
2
.
Enter configuration and change at least one parameter.
Exit configuration. Changes are saved automatically.
8
LATCH ON Function
For use with input
(potentiometer 6K) and
(potentiometer 150K ) and with linear input (0…10V, 0...40mV,
0/4…20mA), you can associate start value of the scale (parameter 6
) to the minimum position of the sensor and value of the scale
end (parameter 7
) to the maximum position of the sensor
(parameter 8
configured as
).
It is also possible to fix the point in which the controller will display 0
(however keeping the scale range between
and
)
using the “virtual zero” option by setting
or
in
parameter 8
. If you set
the virtual zero will reset after
each activation of the tool; if you set
the virtual zero remains
fixed once tuned.
To use the LATCH ON function configure as you wish the parameter
.
3
For the calibration procedure refer to the following table:
2
If on activation the controller does not display
it means no data have been
saved on the memory card, but it is possible to update values.
3
The tuning procedure starts by exiting the configuration after changing the parameter.
