Pixsys ATR 621 series, User Manual

Page: 17 / 100

ATR 621 - User manual 17
Set the controller in

and follow the points below:
Press Display Do
1
PRG
M
Red display shows

2
Decrease or increase to visuali-
ze

(for cycle no.1),

(for cycle no.2) up to

(for
cycle no.15).
6.1.1
Programming of starting setpoint (if enabled)
This is useful for example when the kiln is still hot and cycle has to start from
a lower temperature.
Press Display Do
3
OK
Red display shows

.*
Green display shows “starting
setpoint”.
Otherwise pass to point 5.
At any time press
START
STOP
to exit
programming with storing
modifi ed data.
4
Increase or decrease value on
green display. Enter starting setpoint (starting
temperature)
6.1.2
Programming of the step
Press Display Do
5
OK
Red display shows

.
Green display shows step time.
6
Increase or decrease value on
green display.
NB : Each cycle is composed of
max. 45 programmable steps,
after those it skips automati-
cally to point 12.
Enter step duration in
hour:minutes.
NB
: Set for endless time or --.--
for cycle end (if not all steps are
used) and skip to point 11.
* The two fi rst digits indicate the number of the step which is being modifi ed. Last digit visualizes

if a step duration time is being entered,

if a setpoint value is being entered (ex: temperature
to reach into selected time) and

if the status of the auxiliary output is being entered.