Piusi CUBE B.SMART, Installation, Use And Maintenance Manual

Page: 51 / 60

51
/124
EN
51
/60
This manual belongs to PIUSI S.p.A. The reproduction of all or parts is prohibited.
CUBE
EN (translated from Italian)
21.2 ELECTRICAL/ELECTRONIC CONNECTIONS
PROBLEM POSSIBLE CAUSES POSSIBLE SOLUTIONS
CUBE
B.SMART does
not switch on
Lack of power DUE TO:
• Incorrect connections
• Upstream circuit breaker in OFF
position
• Fuse on power supply interrupted
Check connections
Set circuit breaker to ON position
Check fuse
A driver with
an electronic
key is not
recognized
The electronic key has not been
associated by the MANAGER
The system MANAGER associates the key
to the driver
The electronic key has been damaged
and is no longer recognized by the system
Change the electronic key, the system
MANAGER will also have to delete the
code of the old key and associate the new
key to the driver via WebAPP
The motor does
not start
It has not been connected correctly to the
terminals provided
Check connections, or (if present) check
that the position of the motor switch is in
the ON position
Does not
count during
dispensing
The Pulser that emits the counting signals
is not correctly connected
Check connections
The Pulser that emits the counting signals
is NOT compatible with the electronics
The electronics are designed to receive
a “clean contact” or “Open Collector”
signal as input. If the input signal is an
incompatible voltage signal, in addition
to the malfunction the electronic board is
likely to be damaged
Pulser board damaged Replace Pulser board
The counting is
not accurate
The system is NOT calibrated
Calibrate the system according to the
procedure
The counting
is not accurate
even after
calibration or is
only accurate
at low flow
rates
The signal coming from the Pulser is out of
the ranges acceptable by the electronics
The signal received by the pulser must
be with max. frequency 300 Hz and
Duty Cycle between 10% and 90%.
Beyond these ranges, the system does not
process the received data correctly. The
system must fall within the correct ranges
by interposing other electronic interface
devices (contact the Technical Assistance
for these particular options)