Piusi CUBE B.SMART, Installation, Use And Maintenance Manual

Page: 47 / 60

47
/124
EN
47
/60
This manual belongs to PIUSI S.p.A. The reproduction of all or parts is prohibited.
CUBE
EN (translated from Italian)
PULSER
FILTER
The pulser filter provides additional protection against the risk of foreign
bodies entering the oval gear pulser. As this filter is installed downstream
the pump suction filter, regular checking and cleaning is not required. If the
need arises and/or in case of extraordinary maintenance, it can be cleaned
as described in the PULSER MANUAL, after disassembling the roof of CUBE
B.SMART, using the screws located above it (see exploded drawing).
PULSER The pulser flow meter is a measuring instrument characterized by high
precision, guaranteed by the accuracy of machining and assembly. No
routine maintenance is normally required. Calibration, normally carried out
during the installation of the station, can be carried out again if precision
checks, to be repeated every 3/6 months, recommend so. Calibration is
performed electronically via the management system, and does not require
any intervention on the pulser. For any information, refer to the K600 flow
meter manual.
20.2 EXTRAORDINARY MAINTENANCE
IMPORTANT Maintenance of electrical parts may only be carried out by qualified
electrical or electronic personnel.
Before performing any maintenance, make sure to disconnect the device
from the power line to switch it off and isolate it from the power mains.
If the device is sold without cable, periodically check the grounding circuit
in accordance with the regulations in force.
1 - Firmware update via smartphone, see dedicated section in the APP
manual
2 - Fuse control: to access the fuses it is necessary to open the unit and ac-
cess the parts that are live during normal use, to operate safely disconnect
the general power supply from the unit