Controlling other equipment
08
53
En
Chapter 8
Controlling other equipment
Using the remote control with other
components
The supplied remote control can operate not only this
receiver, but also your TV, DVDplayer and other
components. If the component is listed in the remote
control's memory, you can simply follow the steps in
Recalling preset codes
below. If the component is not
listed, or if you want the remote to learn additional
operations, see
Programming signals from other remote
controls
on page 54.
See
Preset code brands
on page 92 for a list of brands
available for each component.
Note
• TV codes (for example, codes for TV, CATV, Satellite
TV or DTV) can only be assigned to the
TV/SAT
or
TV
CONT
button.
• You can cancel or exit any of the following steps by
pressing
REMOTE SETUP
.
• The default preset setting for all functions is a corre-
sponding Pioneer component. Note that where two
buttons are listed, the first component is the the
default (for example,
DVD/LD
is a Pioneer DVD
player).
Recalling preset codes
The following steps how you how to recall preset codes
for each input source. Use the remote control to do this.
1
Make sure the component you want to control is
switched on.
2
While holding down the REMOTE SETUP button
press 1 to select the preset recall setup mode.
The LED begins to blink.
3
Press the MULTI CONTROL button that matches
the connection for the component you want to
control.
For example, press
DVD/LD
if you want to control the
DVD player that you connected to the
DVD/LD
terminals.
The LED lights continuously.
• Choosing a button that's already assigned will over-
write the old preset (and any other operations you
may have programmed).
• You can't assign the
RECEIVER
or
TUNER
buttons.
4
Point the remote at the component you want to
control and enter the 4 digit setup code
(see
Preset
code brands on page 92
).
The LED blinks.
After a code has been input the component switches on
or off (into standby).
The remote control will return to the previous mode after
thirty seconds of inactivity.
The component you are trying to control will only be
switched on or off (into standby) if that component is able
to be switched on directly by remote control.
If you can't properly enter a preset code, you can still
teach the remote individual commands from another
remote control (see
Programming signals from other
remote controls
below).
5
Repeat steps 3 through 4 for any other compo-
nents you want to control.
6
When you're finished, press the REMOTE SETUP
button to exit.
VSX-54TX_0430.book 53 ページ ２００４年５月６日 木曜日 午後８時７分
