Pioneer CNDV-50MT, Operation Manual

Page: 97 / 142

95
Ch
ap
te
r
8
Cu
st
o
m
isin
g t
h
e A
u
dio
S
o
u
rc
e S
et
tin
g
AV
Switching Auto PI seek
The unit can automatically search for a different
station with the same programming, even during
preset recall.
1
Touch “AUTO PI” in the INITIAL menu.
Touching “ AUTO PI ” switches between “ ON ”
and “ OFF ”.
Switching the auxiliary setting
It is possible to use auxiliary equipment with
navigation unit. Activate the auxiliary setting
when using auxiliary equipment connected to
navigation unit.
1
Touch “AUX” in the INITIAL menu.
Touching “ AUX ” switches between “ ON ” and
“ OFF ”.
Selecting the illumination
colour
This unit is equipped with two illumination
colours, green and red. You can select the
desired illumination colour.
1
Touch “ILLUMI” in the INITIAL menu.
Touching “ ILLUMI ” switches between
“ GREEN ” (green) and “ RED ” (red).
Setting the rear output and
subwoofer controller
This unit’s rear output (rear speaker leads output
and RCA rear output) can be used for full-range
speaker (
REAR SP FULL ) or subwoofer ( REAR
SP SUB. W ) connection. If you switch the rear
output setting to the REAR SP SUB. W , you can
connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, navigation unit is set for rear full-range
speaker connection (
REAR SP FULL ). When
rear output is connected to full range speakers
(when
REAR SP FULL is selected), you can
connect the RCA subwoofer output to a
subwoofer. In this case, you can select whether
to use the subwoofer controller’s (low pass filter,
phase) built-in
PREOUT SUB. W or the auxiliary
PREOUT FULL .
1
Touch “REAR SP” in the INITIAL menu.
2
Touch “REAR SP” to switch the rear
output setting.
When no subwoofer is connected to the rear
output, select
FULL .
When a subwoofer is connected to the rear
output, select
SUB. W .
❒
When the rear output setting is SUB. W ,
you cannot change the subwoofer
controller.
3
Touch “PREOUT” to switch the
subwoofer output or non fading output.
❒
Even if you change this setting, there is no
output unless you turn “
NON FADING ” or
“ SUB WOOFER ” in the AUDIO menu
“ ON ”.
➲
Using non fading output
➞
Page 91
➲
Using subwoofer output
➞
Page 91
❒
If you change the subwoofer controller
(
REAR SP ), the subwoofer output ( SUB
WOOFER ) and non fading output ( NON
FADING ) in the AUDIO menu return to
the factory settings.
❒
Both rear speaker leads output and RCA
rear output are switched simultaneously in
this setting.
Switching the sound muting/
attenuation
Sound from this system is muted, attenuated or
mixed automatically in the following cases:
• When a call is made or received using a
cellular telephone connected to navigation
unit.
• When the voice guidance is output.
1
Touch “TEL/GUIDE” in the INITIAL
menu.
Each touch of the “ TEL/GUIDE ” changes the
settings as follows:
•
MUTE – Muting
• ATT – Attenuation
• NORMAL – Volume does not change
❒
The sound is turned off, no audio
adjustment is possible.
❒
When a phone connection is made, MUTE
or ATT is indicated.
In
it
ia
l S
et
tin
gs
MAN-CNDV-50MT-EN.book Page 95 Wednesday, May 4, 2005 1:49 PM