Pioneer CNDV-50MT, Operation Manual

Page: 93 / 142

91
Ch
ap
te
r
8
Cu
st
o
m
isin
g t
h
e A
u
dio
S
o
u
rc
e S
et
tin
g
AV
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1
Touch “LOUDNESS” in the AUDIO menu.
2
Touch “ON” to turn loudness on.
To turn loudness off, touch “ OFF ”.
3
Touch 4 or 6 to select a desired level.
Each time you touch 4 or 6 selects level in
the following order:
LOW (low) – MID (mid) – HIGH (high)
Using subwoofer output
This unit is equipped with a subwoofer output
which can be turned on or off.
• When the subwoofer output is on, you can
adjust the cut-off frequency and the output
level of the subwoofer.
1
Touch “SUB WOOFER” in the AUDIO
menu.
When PREOUT (the subwoofer controller
setting in INITIAL menu) is FULL , you
cannot select “ SUB WOOFER ”.
➲
Rear speaker setting
➞
Page 95
2
Touch “ON” to turn subwoofer output on.
To turn subwoofer output off, touch “ OFF ”.
3
Touch “REVERSE” or “NORMAL” to
select the phase of subwoofer output.
4
Touch “+” or “–” to adjust the output
level of the subwoofer.
+6
– –6 is displayed as the level is increased
or decreased.
5
Touch 4 or 6 to select cut-off frequency.
Each time you touch
4
or
6
selects cut-off
frequencies in the following order:
50 – 80 – 125 (Hz)
Only frequencies lower than those in the
selected range are output from the subwoofer.
Using non fading output
When the non fading output setting is on, the
audio signal does not pass through navigation
unit’s low pass filter (for the subwoofer), but is
output through the RCA output.
1
Touch “NON FADING” in the AUDIO
menu.
Only when PREOUT (the subwoofer
controller setting in
INITIAL
menu) is
FULL
,
you can select “ NON FADING ”.
➲
Rear speaker setting
➞
Page 95
2
Touch “ON” to turn non fading output on.
To turn non fading output off, touch “ OFF ”.
3
Touch “+” or “–” to adjust the output
level of the non fading.
+6
– –6 is displayed as the level is increased
or decreased.
Using the high pass filter
When you do not want low sounds from the
subwoofer output frequency range to play from
the front or rear speakers, turn the
HPF
(high
pass filter) on. Only frequencies higher than
those in the selected range are output from the
front or rear speakers.
1
Touch “HPF” in the AUDIO menu.
2
Touch “ON” to turn high pass filter on.
To turn high pass filter off, touch “ OFF ”.
3
Touch 4 or 6 to select cut-off frequency.
Each time you touch 4 or 6 selects cut-off
frequencies in the following order:
50 – 80 – 125 (Hz)
When
PREOUT (the subwoofer controller
setting in INITIAL menu) is SW , the HPF
function is effective for front speakers only.
Audi
o Adj
u
st
me
nt
s
MAN-CNDV-50MT-EN.book Page 91 Wednesday, May 4, 2005 1:49 PM