Pinnacle Technology PP7X Series, Operation Manual

Page: 66 / 76

63
1 04 4 Double-width mode selected.
0 00 0 Double-height mode not selected.
3
1 08 8 Double-height mode selected.
4-6 -- -- Undefined.
0 00 0 Underline not selected.
7
1 128 80 Underline selected.
z
FS S n1 n2
Set Chinese character space amount
Format: ASCII FS S n1 n2
Decimal 28 83 n1 n2
Hex 1C 53 n1 n2
Range:
0 ≤ n1 ≤ 255, 0 ≤ n2 ≤ 255
Initial value:
n1=0, n2=0
Description:
1. Sets the Chinese character space amount and right space amount.
2. Left space amount: n1 x (basic calculated pitch)
3. Right space amount: n2 x (basic calculated pitch)
Note:
∗
The space amount set by this command is the amount when using standard sized characters. When expanding
characters more than double in the horizontal direction, the space amount is [set amount x horizontal direction
magnification].
∗
Space amount can be set independently for both the standard and page modes.
∗
The basic calculated pitch is set by GSP (Set basic calculated pitch). Also, after setting the Chinese character
space amount, it is not affected even if the basic calculated pitch is changed.
∗
If there are fractions in the result, correct to the minimum mechanical pitch and discard.
∗
Use the basic calculated pitch (x) for the horizontal direction in standard mode.
∗
In page mode, the basic calculated pitch that is used according to the starting point is shown below.
a. When the starting point is specified to be upper left or lower right by the ESC T command (Character print
direction selection in page mode), the basic calculated pitch (x) for the horizontal direction is used.
b. When the starting point is specified to be upper right or lower left by the ESC T command, the basic
calculated pitch (y) for the vertical direction is used.
c. The maximum value for the left or right space for Chinese characters is approximately 35.893 mm (255/180
inches). Specifications that exceed the maximum value are rounded off to that value.
Reference:
GSP
z
ESC I
Execute partial-cut (one point left uncut)
Format: <1B>H<69>H
Description: Execute a partial-cut of the paper.
z
①
GS V m GS V m n
②
Select paper-cut mode and cutting paper
Format:
①
ASCII GS V m
Hex 1D 56 m
Decimal 29 86 m
②
ASCII GS V m n
Hex 1D 56 m n
Decimal 29 86 m n
Range:
①
m = 0
，
48
，
1
，
49