Hunter-Pro Series
29
Diagram 30.
TRV/TRU-100 mounting holes
3.
Connect the antenna to the transmitter. Verify that the antenna is straightened.
4.
Verify that the supplied 5-wire cable is firmly attached to the transmitter’s Molex terminal
(labeled “To the system”).
5.
Connect the other end of the cable to the “TRANSMITTER” connector on the control panel.
Diagram 31.
Connecting the TRV/TRU-100
Transmitting in the second frequency
1.
Connect one end of the supplied 2-wire cable to the transmitter’s F2 Molex socket.
2.
Connect the other end of the cable to the control panel, depending on the desired transmitter
mode of operation:
a.
To transmit only in the second frequency, connect the cable to GND (-).
b.
To use the channel on specific event types (e.g. Special Burglary 1 alarms), connect the
trigger wire between F2 and an output terminal on the control panel and set a proper
output type to trigger it see section 10.2, on page 65.
GSM-200
TRV/TRU-100
Control panel case’s top side
TRV/TRU-100
Control Panel
To the
System
F2 Program
TRANSMITTER
Second channel triggering wire.
Connect it to (-) or to a triggering output
1
