Hunter-Pro Series
25
1.5.21.
MIC-200 microphone
1.
Connect the MIC-200 to the AUDIO terminals as described in the next table and diagram.
2.
In the "Output configuration" menu, set the AUDIO output polarity to ‘+’ see section 10.4, on
page 67.
Note that the MIC-200 is supplied without wires.
MIC-200 Control
panel
CON
AUDIO CONT
OUT
AUDIO IN
(-)/(+)
(-)/(+)
Diagram 24.
MIC-200 wiring
1.5.22.
VU-20U Voice message module
The VU-20U is a voice message recorder, which enables to play up to 2 messages via the phone,
when the alarm is set off.
Single message wiring
To use the VU-20U for a single message:
1.
Connect the Green wire (M1) to any
output and set the output to be
triggered by the "Audio control" output
type (including in zone expanders) see
section 10.2, on page 65.
2.
Connect the +/- wires to the control
panel's zones voltage.
3.
Connect the Blue wire to the control
panel's AUDIO IN terminal.
4.
The Yellow and white wires are not
in use.
Diagram 25.
VU-20U single message wiring
Single message setting
To set a single message:
1.
In the "Output configuration" menu, select the output to which the VU-20U will
be connected to and triggered by see section 10.2, on page 65.
2.
Set the "Audio control" (or any other) output type to trigger the output.
3.
Set the output partitions.
Z8
-
+
MIC-200
Control panel
Zones’ voltage
AUDIO IN
Control panel
B
lu
e
R
e
d
B
la
c
k
G
re
e
n
Y
e
llo
w
A
ud
io
VU-20U
W
h
ite
M
1
M
2
C
O
N
T
+1
2V
G
N
D
To any output
CO
N
T
IN
O
U
T
A
U
D
IO
AG
ND
Z7
Z8
-
+
Z O N E S
Z5
Z6
