Captain-i - Installation Guide
5
Chap 1.
Introduction
This guide provides the installation, wiring and programming instructions for PIMA’s
CAPTAIN-i intruder alarm system. CAPTAIN-i has many features that fits customer’s
individual needs, and yet it remains easy to install and simple to program and use,
both by the end-user and the installer.
CAPTAIN-i is secured against radio-frequency (RF) interferences and electro-magnetic
interferences (EMI).
Safety Instructions
Your CAPTAIN-i Alarm System has been registered in accordance with EN60950
and its rules. EN 60950 requires us to advise you the following information:
1. In this alarm system hazards of fire and electric shock exist. To reduce the risk of
fire or electric shock, do not expose this alarm system to rain or moisture. Pay
attention: Telephone cords could be a good conductor for lightings energy.
2. Do not open the door of the alarm system. Dangerous high voltages are present
inside of the enclosure. Refer servicing to qualified personnel only.
3. This alarm system should be used with AC 230V/110V, 50Hz, protected by anti
electric shock breaker. To prevent electric shocks and fire hazards, do NOT use
any other power source.
4. Do not spill liquid of any kind onto the unit. If liquid is accidentally spilled onto the
unit, immediately consult a qualified service.
5. Install this product in a protected location where no one can trip over any line or
power cord. Protect cords from damage or abrasion.
6. Disconnect all sources of power supply before proceeding with the installation. Pay
attention: do not install low voltage wires near by AC power wires they should be
separated.
7. Connect the AC transformer output to the terminal block on the control panel as
marked.
8. Connect the AC line cord to line power terminals as marked. (GND; N; L)
Important! Regarding parameters such as Date and Time, User codes and
Telephone numbers, refer to the CAPTAIN-i’s User Guide.
1.1
Release Note - Version 6.0
<New>
PCB with a new jumper - JP3 - that is set according to the EOLs
<New>
GSM-200 module connectivity
<New>
VU-20N voice unit
