Captain-i, Installation Guide
30
Notes:
Scroll through the various functions with
and
Marking “+” under a parameter enables it. Marking a “-” disables it.
In order to change the mark from “-” to “+” (and vise versa) use
To confirm,
[
Par.
Descr. Settings
P
Telephone
The system will perform all the functions associated
with the telephone, such as: dial to Monitoring Station,
dial to private numbers, respond to a call, test the line
during operation, etc. If the CAPTAIN-i is not connected
to a telephone line, program a “-” to avoid telephone
FAULT display
P
Remote Test
by Phone
If two or maximum three rings are detected while the
system is ARMED, the system will dial to the Monitoring
Station by telephone and report a TEST event
T
Remote Test
by Radio
If two or maximum three rings are detected while the
system is ARMED the system will transmit a TEST event
by radio
P
Automatic Test
to Monitoring
Station by
Phone
The system will send a TEST event to the Monitoring
Station by telephone at a preset time interval
(see page 25)
T
Automatic Test
to Monitoring
Station by
Radio
The system will send a TEST event to the Monitoring
Station by radio (see page 25)
B
Automatic
Zone Bypass
If this feature is enabled, a zone that causes an alarm 3
times will be automatically bypassed until the system is
disarmed. Note that only the zone that caused the
alarm will be bypassed
5.4.3
System configuration 2 (config 2)
[
[
[
:
TDZBRT DialTnBp
-----+ Config 2
Par.
Descr. Settings
T
Dial Tone
Bypass
Enables the system to bypass dial tone detection before
dialing. This is intended for places with non-standard dial
tones. When this option is enabled, there will be no
telephone line check when the panel is armed or disarmed
