Captain-i Installation Guide
31
Par.
Descr. Settings
D
Delayed on “+” The system will be armed after an arming report is
received by the Monitoring Station. “Message
received” is displayed in the LCD display area
Z
Zone
Display
“+” When the system is armed, the zone status is shown
on the lower line of the LCD display (as it is when in
disarmed mode).On the LED keypad, open zones are
displayed in both ARMED and DISARMED states
B
Keypad
Buzzer
Activated
with Alarm
“-“
Keypad buzzer is not activated when the alarm is
activated.
“+” Keypad buzzer is activated every time the alarm is
activated
R
Reset per
Zone
“-“: Restore is reported only for siren and is only after it
stops, without indicating which zones are opened or
closed.
“+”: Restore of zone after alarm is reported. Reports
which zones have been closed and which are still
open after siren stops.
Note: Do not use this parameter with PAF (PIMA) format
T
Tone
Dialing
“+”
The system will dial using tones.
“-“
The system will dial using pulses
5.4.4
System configuration 3 (config 3)
[
[
X3:
SDVKKG Phon.Snap
------ Config 3
Par.
Descr. Settings
S
Line
Snapping
This feature allows the CAPTAIN-i to share the phone line with
other devices such as telephone or answering machine. When
calling to the control panel, the control panel picks up the line
after a programmable number of rings (see section “Setting
telephone line characteristics
”
on page 29).
Note: When using this option do not connect a fax machine or
modem to the same line as that of the control panel
D
Download
Disable
Setting a “+” will block the Up/Download process if the primary
code has not been entered. Thus, remote download via
telephone lines cannot be done without the customer being
present (Entering the Primary Code and pressing
twice
allows you to unblock the Up/Download process for 4 minutes)
V
Voice Unit
“+” Programs the system to a voice unit that is connected to
the CAPTAIN-i. In this case the CAPTAIN-i will not sound the
synthesized alarm tone when dialing to a telephone
Note: The voice unit is activated per zone. To fully program the
system if a voice unit is connected, two things must be done: (1)
A “+” must be set under the G option in the Zone Response
