6-17
Operating Manual: PMImicro diag
Time characteristics
Set the
operator timeout
and
flash frequency
.
Operator timeout
Once you have operated a key on the PMImicro diag, the PMImicro diag
waits for the next entry. If this entry does not occur within the set
Operator
timeout
, the display on the PMImicro diag will return to the highest-priority
event message.
INFORMATION
If you are in a password-protected area, you will need to log in again if the
Operator timeout
has elapsed.
Proceed as follows:
1. Hold the <ESC> key down for three seconds. This will access the main
menu.
2. Using the navigation keys, select
Configuration
.
3. Press <ENTER>.
4. Using the navigation keys, select
Time characteristics
.
5. Press <ENTER>.
6. The selection window for
Operator timeout
is pre-selected.
7. Press <ENTER> and the selection window turns black.
8. Using the navigation keys, set the required value.
The following values are available for selection:
• 5 minutes
• 2 minutes
• 90 seconds
• 60 seconds
• 30 seconds
9. Press <ENTER>.
Your selection is saved.
10. Press <ESC> to exit the menu.
