Commissioning
Operating Manual PMCprotego S2-2(-C)
1002529-EN-04
55
7
Commissioning
7.1
Safety guidelines
When commissioning/recommissioning, please note the following:
}
Secure the site in accordance with the regulations (barrier, warning signs etc.). The
system may only be commissioned/recommissioned by qualified personnel.
}
Please refer to the information and specifications stated in the operating manual of the
relevant programmable control system.
}
During commissioning/recommissioning, make sure that no personal injury and/or ma-
terial damage can occur, even if the plant/machine moves unintentionally.
}
When commissioning the safety card, please read the safety guidelines in the "Com-
missioning" chapter in the instructions for the servo amplifier.
DANGER!
Risk of electrocution!
Never wire the electrical connections on the servo amplifier while voltage is
applied.
Switch off the mains voltages and 24 V supply!
Make sure that the control cabinet is made safe, e.g. through an access
lock or warning signs. Do not switch on the voltages until the system is com-
missioned!
WARNING!
Risk to life from the automatic start-up of the motor!
The motor can be set in motion immediately if the option "Set software en-
able when booting [AENA]" is set in the commissioning software PASconfig
SDrive:
– after the safety card has run-up
– when recommissioning after a fault
Appropriate measures should be taken so that the start of the machine does
not create a hazardous situation.
