1.1. Surface Protection
Machine parts are protected against corrosion by powder coating or a primer and two-component polyurethane varnish. Sliding
surfaces are coated with anti-corrosive oil. Surfaces of other parts and components of the machine are treated by galvanization or
blackening.
1.2. Packing
The machine is supported on wooden beams, which provide a space of approximately 100mm from the ground for the purpose of the
transport and loading with a forklift. The machine is packed in a stretching foil that protects it against weather influence during
transport.
Standard accessories:
• 1 pc. metal saw blade, bimetal M42 (mounted),
• 1 pc. band saw instruction manual,
1.3. Disassembly/Repacking
Disconnect the machine from the mains • empty and clean the metal chip tank and the coolant tank • clean the machine • apply
anticorrosive oil on the sliding surfaces • before the transport, unscrew the filling cap from the hydraulic unit and replace it with
a transport cap, see section 4.10. • fix the arm for transport • lift the machine and place it on beams • observe the distance of
approximately 100 mm from the ground for the transport with the forklift • make sure that all protective covers
of the machine are in place and fastened • add the machine accessories
1. Transport and Storage
When transporting the machine, use tensioning straps to prevent movement. Thread the straps through the yellow consoles located
in the corners of the machine (see picture). It is recommended to transport and lift the machine only with a forklift. Forks of the forklift
have to be inserted under the machine base, perpendicular to the secured arm from material feed direction, or from the side. When
handing the machine with a forklift, always make sure that the machine is balanced on the forks.
Caution: used coolants belong to the category of special waste!
Only a person with adequate electrician qualifications can disconnect the machine from the
mains!
1.4. Disposal
When the machine has been definitely put out of operation, it should be disposed of in accordance with the provisions valid in the
respective country. We recommend that you contact a specialist waste disposal service.
2. Technical Data
Machine noise
- measured in conformity with ČSN EN ISO 3746:2011
The acoustic pressure level at the workplace: 76 dB (A), acoustic power level: 91 dB (A).
The measured values exceed the value specified in the Government Regulation No. 176/2008, section 1.7.4.2, article u) and
therefore ear protectors must be used during the machine operation. The measurement was carried out while the machine was in
a steady state and the saw blade speed was 80m/min. During the operational state with a technical load, the most frequently used
technological process was measured. Noise levels measured on the machines may vary depending on the type of cut material, saw
blade speed and other factors.
