PicoPhone series – loudspeaking phones
Page
13
.
C
No function.
D
Door key on device
Open/unlock door and end conversation with door phone
when door opening signal has been activated in 1 second. Go
back to parked telephone conversation (the user will be able
to hear doorlock/dooropener operate for 1 second).
E
Telephone key on device
End conversation with door phone without open/unlock door
and go back to telephone conversation.
F
Volume adjustment in steps from 1-5.
Automatic answering key
on device
Enable/disable automatic answering function.
4.8.3 Door phone 1 and 2
Picolo and PicoCombi can be connected to 2 different outdoor door phone units.
When a bell button is pressed a chime will sound (“ding-dong”). A two way voice controlled
communication will be established with the use of remote controller, door switch on device,
external switch (connected to “Door” at the reverse of the device) or automatically if
automatic answering function is enabled.
If the automatic answering function is enabled the communication will be established
automatically 5 seconds (programmable) after someone has pressed the bell button. Before
connection, there will appear a warning tone from the device. When the communication is
established, the user may open/unlock the door. The signal to the door opener/door lock will
be active for 5 seconds.
The conversation at the door phone lasts until the user himself disconnect, or until timeout
(programmable). Before disconnection caused by timeout there will come a beep 5 seconds
and a beep 2,5 seconds before the disconnection from the device as a prewarning.
If both connections are used, the device will normally hook up to door phone 1 (“primary”).
If someone press the bell button at outdoor unit 2, then door phone 2 (“secondary”) will be
available for 30 seconds (programmable time, can be changed in advanced programming
mode). This means that the user has 30 seconds (programmable) to answer the door phone 2.
If timeout, the user will get in connection with door phone 1. The procedure for connection to
door phone 1 and 2 is the same for both. It is only possible to get in touch with one outdoor
unit at the same time.
It is possible to let a light indicator illuminate when a door is opened. If this function is
connected, the light indicator above the door key on the device will illuminate.
4.9 Volume control
Volume adjustments for the telephone function on the PicoPhone and the PicoCombi can be
adjusted with the remote controller in 5 steps. If the volume has been changed, the new value
is stored and used for later telephone conversations. When pressing “F” on remote controller
the volume will increase and it will be indicated by one short “beep” for each press. When
changing from volume level 4 to level 5 (maximum), it will be indicated by a long “beep”.
The next key press on “F” will change the volume to 1 (minimum).