PicoPhone series – loudspeaking phones
Page
17
.
01-50
<Existing number
>/ Empty
<telephone number>
Pressed numbers
D
Saved
Telephone number
will be stored.
01-50
<Existing number
>/ Empty
D
Saved
Telephone number
will be deleted.
When a telephone book number is given, the stored telephone number will be played back
digit by digit. If no number is stored, the word “
empty
” will be played back.
When a number is entered, all digits will be played back one for one. If the keystrokes are
faster than the speech, the digits will be queued and played back one for one. The
playback will be interrupted by key “D” (store) or “E” (exit programming mode).
If more than 50 digits are entered, all digits after the 50th will be ignored. The ignored
digits will neither be played back.
The telephone numbers may contain the following:
Digit/letter
Belonging playback
Function
0-9
0-9
DTMF 0-9
A
*
DTMF *
B
#
DTMF #
C
Empty
“Clear”. Deleting all digits. Wait for new digits.
F
Pause
Stores a pause with the same length as for the one
programmed as a part of a prefix (done in
advanced programming mode).
5.3 Programming
– super user
It is intended that this mode shall be entered by technicians with a good insight in the product.
It is important that the technician choose the best settings so the user can make the most out of
the benefits of the product. Especially with the built in speech functions which are available.
When installing a device you should as a first job enter advanced programming mode and
record speech to the auditive feedback (point 31 in the list). This should be done because this
feedback will be a very good help in programming mode.
Observe that:
Auditive feedback is indicated with
italic
letters.
Comma “,” in the table indicate possible values, i.e. “0,1” indicates “0” or “1”.
Values in parenthesis are default values.
“C” can be pressed everywhere in this mode. The sequence is interrupted and the device is
ready for a new sequence.
To enter this mode do as the following text says:
1.
Press “0 – F” on the remote controller while device is in standby mode.
2.
Thereafter, and within 3 seconds, press and hold the key for “automatically answering
function” on the device for 3 seconds.
3.
When the light indicator for “automatic answering function” is executing rapid flashing
you have entered the advanced programming mode.
4.
Release the key for automatically answering function.
There are given an additional explanation in the chapter beneath the table for lines marked *.
