PCM-061/phyCORE-i.MX7 System on Module
L-821e_2
© PHYTEC America L.L.C. 2017
25
3
Jumpers
The phyCORE-i.MX7 provides 18 solder jumpers for configuration purposes. These jumpers have been installed in their
default configurations prior to delivery.
If manual jumper modification is required, please ensure that the board as well as surrounding components and sockets
remain undamaged while de-soldering. Overheating the board can cause the solder pads to loosen, rendering the module
inoperable. Carefully heat neighboring connections in pairs. After a few alternations, components can be removed with
the solder-iron tip. Alternatively, a hot air gun can be used to heat and loosen the bonds.
Figure 5. Jumper Numbering Schemes
The bold items in
Table 4
below represent the default configuration for each jumper. The table also describes the function
of each jumper as well as each alternative position. Note that each solder jumper on the phyCORE-i.MX7 should be
populated with a 0-ohm 0402 resistor.
