Phytec nanoModul-164, Quick Start Instructions

Page: 7 / 96

Introduction

PHYTEC Meßtechnik GmbH 2003 L-379e_4
3
For more information and example updates, please refer to the
following sources:
http://www.phytec.com - or - http://www.phytec.de
support@phytec.com - or - support@phytec.de
http://www.keil.com
support@keil.com
1.4 The PHYTEC nanoMODUL-164
The nanoMODUL-164 is intended for use in memory-intensive appli-
cations and in running within a CAN-bus network. Half of the size of
a credit card (47 by 38 mm.), the standard board is equipped with the
Infineon C164CI controller as well as a Real-Time Clock which, like
the SRAM, can be buffered by an external battery. The standard
module runs at a 20 MHz internal clock speed (delivering 100
instruction cycles/ns) and offers 256 kByte (up to 1 MB) SRAM and
256 kByte (up to 1 MB) Flash on-board for DATA and CODE
storage. PHYTEC FlashTools for Windows enable easy on-board
download of user code to the external Flash device.
The nanoMODUL-164 is fitted with one RS-232 transceiver, an I²C
RTC and a CAN-bus interface. All controller signals and ports extend
to pin rows aligning two edges of the board. These pins provide a 16-
bit bi-directional I/O port and 64 free port lines, including 8 analog
inputs with 10-bit resolution. The nanoMODUL-164 has an industrial
temperature range from 0 to 70 degrees ºC (with extended range from
-40 to 85 degrees ºC except RTC only from –30 to 70 degrees) and
requires only a 300 mA power source.