Phytec nanoModul-164, Quick Start Instructions

Page: 21 / 96

Getting Started

PHYTEC Meßtechnik GmbH 2003 L-379e_4
17
Figure 2: Suitable Development Board Jumper Settings
•
Configure Jumper JP1 on the Development Board as indicated
below to supply the board through the power socket (P3).
•
Connect the RS-232 interface of your computer to the DB-9 RS-
232 interface on the Development Board (P1) using the included
serial cable.
•
Using the included power adapter, connect the power socket on the
board (P3) to a power supply (refer to Figure 3 for the right
polarity).
+8..12VDC
GND
500mA
center hole
2,0mm
5,5mm
- +
polatity:
Figure 3: Power Connector
•
Simultaneously press the Reset (S1) and Boot (S2) switches on the
Development Board, first releasing the Reset (S1) and then, two or
three seconds later, release the Boot (S2) switch.
This sequence of pressing and releasing the Reset (S1) and Boot (S2)
switches renders the nanoMODUL-164 into the Bootstrap mode.
FlashTools for Windows must always be operated in this mode. See
section 5.1.1 for more details. Ensure that the terminal program
flasht.exe is always invoked only after first resetting the board.