Phytec nanoModul-164, Quick Start Instructions

Page: 24 / 96

nanoMODUL-164 QuickStart Instructions
20 
PHYTEC Meßtechnik GmbH 2003 L-379e_4
2.3.2 Downloading Example Code with FlashTools for DOS
•
Start FlashTools for DOS for your nanoMODUL-164 by selecting
either the FlashTools (COM1) or FlashTools (COM2) icon within
the PHYTEC Rapid Development Kit|nanoMODUL-164 program
group. Which icon to choose depends on the serial port used to
connect to the target system.
If you have a nanoModul-164 with 1 MB SRAM or 1 MB Flash use
the icons FlashTools Max (COM1) or FlashTools Max (COM2).
The microcontroller firmware tries to automatically adjust to the baud
rate entered in the command line within the properties of the link.
However it may occur that the predefined baud rate can not be
reached. This results in FlashTools omitting the loading procedure
and never showing the main menu. In this case, try incrementally
lower baud rates to establish a connection. Before further connection
attempts be sure to leave FlashTools by pressing function key <F1>
and then to reset the target hardware and force it into Bootstrap mode
as described in section 2.2.
•
If properly invoked, FashTools will load to the RAM of the
nanoMODUL-164. The active loading process is indicated by a
rotating cursor bar.