Phytec nanoModul-164, Quick Start Instructions

Page: 68 / 96

nanoMODUL-164 QuickStart Instructions
64 
PHYTEC Meßtechnik GmbH 2003 L-379e_4
3.8.5 Downloading the Output File
3.8.5.1 Downloading with FlashTools for DOS
•
Exit Keil
µ
Vision.
•
Reset the target hardware to render it in Flash Programming mode
by simultaneously pressing the Reset (S1) and Boot (S2) switches
on the Development Board and then releasing first the Reset (S1)
and, two or three seconds later, release the Boot (S2) switch
•
Start FlashTools for DOS for your nanoMODUL-164 by selecting
either the FlashTools (COM1) or FlashTools (COM2) icon within
the PHYTEC Rapid Development Kit|nanoMODUL-164 program
group. Choose the icon that corresponds to the serial port used on
your host-PC to connect to the target system.
If you have a nanoModul-164 with 1 MB SRAM or 1 MB Flash
use the icon´s FlashTools Max (COM1) or FlashTools Max
(COM2).
•
FlashTools will load to the RAM of the nanoMODUL-164. The
active loading process is indicated by a rotating cursor bar.
•
After FlashTools has loaded, the main FlashTools menu appears
on the screen.
•
Enter ‘2’ to choose the Erase entire Flash-Area command and
enter ‘Y’ to confirm erasure of all unprotected sectors of Flash
memory. You can see the Flash sectors being erased in the
FlashTools window. When the all sectors are erased, the main
FlashTools menu reappears.
•
Enter ‘4’ to choose the Load INTEL-hexfile command and press
the function key <F2> to specify the input file.
•
The hexfile for download was created during the Make process
and is located in the directory of the Hello2 project. Enter the
correct drive and path to the Hello2 hexfile (default location
C:\PHYBasic\nM164\Demos\Keil\Hello2\Hello2.h86) and press
<Enter>. The download immediately starts. You can watch the