Phytec nanoModul-164, Quick Start Instructions

Page: 64 / 96

nanoMODUL-164 QuickStart Instructions
60 
PHYTEC Meßtechnik GmbH 2003 L-379e_4
3.7.2 Downloading with FlashTools for Windows
•
Exit Keil
µ
Vision2.
•
Render the target hardware and force it into Flash programming
mode by simultaneously pressing the Reset (S1) and Boot (S2)
switches on the Development Board, releasing first the Reset (S1)
and then the Boot (S2) switch
•
Start FlashTools for Windows
•
At the Serial Interface tab of the FlashTools for Windows
Worksheet, specify the proper serial port and transmission speed
for communication between host-PC and target hardware and
click the Load Flashtools button to transfer the modul based part
of the FlashTools for Windows to the target hardware.
•
Select the right protocol (default RS232) for further use of the
FlashTools for Windows.
•
Returning to the FlashTools for Windows Worksheet, choose the
Sectors Utilities tab, highlight Sector #0 in the Sectors Erase
section of the tab and click on the Erase Sector(s) button to erase
this memory sector
•
Wait until the status check in the lower left corner of the
FlashTools for Windows Worksheet finishes, returning the
connection properties description to the lower left corner of the
window
•
Next choose the File Download tab and click on the File Open
button
•
Type the complete pathway and name of the file you wish to
download
C:\PHYBasic\mM164\Demos\Keil\Blinky2\blinky2.h86
directory (default location)
•
Click on the Download button and view the download procedure
to the board in the status window
•
Returning to the Communication tab, click on the Disconnect
button
•
Press the Reset button (S1) on the Development Board.