Phoenix Contact Axioline F, User Manual, Page: 75 / 86

Diagnostic messages for parameter errors for PROFIsafe
105739_en_04 PHOENIX CONTACT
75
B 3 Diagnostic messages for parameter errors for
PROFIsafe
Table B-2 F-Parameter parameter errors
Error code Error cause Remedy
dec hex
64 40 The parameterized F_Destination_Address does not
match the PROFIsafe address set on the module
(F-Module).
Make sure that the PROFIsafe address of the
module and the value in
F_Destination_Address are the same.
65 41 Invalid parameterization of F_Destination_Address.
Addresses 0000
hex
and FFFF
hex
are not permitted.
Correct value.
66 42 Invalid parameterization of F_Source_Address.
Addresses 0000
hex
and FFFF
hex
are not permitted.
Correct value.
67 43 Invalid parameterization of F_WD_Time.
A monitoring time of 0 ms is not permitted.
Correct value.
68 44 Invalid parameterization of F_SIL.
The safety module (F-Module) cannot support the
required SIL.
Use a device with the required SIL.
The safety module achieves SIL 3, maximum.
69 45 Invalid parameterization of F_CRC_Length.
The CRC length generated by the safety module
(F-Module) does not match the required length.
Check device description.
70 46 Invalid F-Parameter record version.
The safety module (F-Module) version does not match
the required version.
Check device description.
Only V2 mode permitted.
71 47 The checksum determined by the safety module
(F-Module) via the PROFIsafe parameters (CRC1) does
not match the CRC1 transmitted in the parameter
telegram.
Check F-Parameters. Repeat calculation.
72 48 Device-specific diagnostics.
73 49 Save i-Parameter watchdog time exceeded.
74 4A Restore i-Parameter watchdog time exceeded.
75 4B Invalid F_iParCRC. Correct value.
76 4C F_Block_ID is not supported. Check device description.
77 4D Reserved.
78 4E Reserved.
79 4F Non-specified (unknown) error.