Philips HR1050, Manual

Page: 13 / 312

,
The temperature shown on the display is ‘- -’ and the time shown is
00:00.
Note: If you do not use the appliance for 10 minutes, it goes into standby
mode to save energy. In this mode, the start/pause button flashes every 10
seconds. If you want to switch the appliance back on, press the start/pause
button.
Note: If the appliance is still hot but is cooling down, it goes into standby mode
to save energy. The ‘heating plate hot’ light lights up as long as the heating
plate is hot. If you want to switch the appliance back on, press the start/pause
button.
Note: If you switch off the appliance or if you unplug the appliance, the
‘heating plate hot’ light goes out. However, the heating plate may still be hot.
2 Press the temperature increase or decrease button one or more
times to set the required temperature.
,
The set temperature is shown on the display. The temperature flashes
to indicate that the appliance is changing the temperature.
,
When the red ‘heating plate hot’ light on the display lights up, the
heating plate is hot and must not be touched.
,
When the heating plate or bottom of the pot has reached the set
temperature, the temperature on the display stops flashing. The
appliance maintains the set temperature while you can do something
else.
Note: Due to variations in ambient temperature it might happen that the
temperature on the display starts flashing again.
Note: If you press the temperature increase and decrease buttons briefly at the
same time, the temperature is reset to zero (‘- -’).
Note: If you press the temperature increase and decrease buttons at the same
time for 3 seconds, you can switch from °C to °F and back.
EnglisH
13