PFT G 5 c FU, Operating Manual

Page: 25 / 56

PFT G 5 c FU 230V Operating Manual Issued: 09.2007
Knauf PFT GmbH & Co. KG
25
For cleaning, the hoses and mortar pressure gauge are connected to the water
bleeder valve using the adapter (in the tool bag). This protects the pump from
damage. A water-soaked sponge ball must first be pressed into the hose inlet.
Then open the water valve until the sponge ball comes out of the end of the hose.
For different hose diameters, the hoses should be cleaned separately with the
appropriate sponge balls.
Repeat this procedure if the hoses are heavily soiled.
Clean the finishing plaster device separately under running water.
Close the water intake valve.
Depressurize the water hose by opening and then carefully disconnecting the water
valve at the side.
Remove power supply.
Empty the material hopper if the machine will not be used for several days.
To do so, open the hopper cleaning flap and remove the star wheel if necessary.
WARNING!
Prior to dismantling the hopper cleaning flap, the main switch must be turned off or the
power supply must be disconnected.