Pfaff 3586-22/02, Instruction Manual, Page: 35 / 158

Set-up
35
9
.03
Winding the bobbin thread / adjusting the bobbin thread tension

Switch on the machine, see chapter 8 . 03 Switching the machine on/off .

Fit the empty bobbin 1 onto the bobbin winder spindle 2 with the rest thread chamber on
the outside.

Thread in the thread as shown in Fig. 9-03 and wind it round the bobbin 1 a few times in
an anti-clockwise direction.

Switch on the bobbin winder by pressing the bobbin winder spindle 2 and the lever 3
simultaneously.
The bobbin 1 fi lls up during sewing.
If the machine is only run for bobbin winding (without sewing), a bobbin case
must be fi tted in the hook!
Otherwise a jammed thread may damage the hook!

The tension of the thread on the bobbin 1 can be adjusted with the knurled thumb screw 4 .

The bobbin winder stops automatically when the bobbin 1 is suffi ciently full.

Remove the fi lled bobbin 1 and cut the thread with the knife 5 .

The fi ll amount of the bobbin 1 can be adjusted with the pin 8 (loosen the screw 9 and
tighten it again)
If the thread is wound unevenly:
  
Loosen the nut 6 .

Turn the thread guide 7 accordingly.

Tighten the nut 6 .
See chapter 13.06 .07 Bobbin winder to adjust the fi ll amount.
Fig. 9 - 03
4
3
1
2
6
7
5
8
9