Pfaff 3586-22/02, Instruction Manual, Page: 122 / 158

Adjustment
122
Group P
arameter
Description Set
ting
range Set v
alue
200
206 End stitch condensation stitch count 1 - 20 5
207 Angle seam end [°] 0 - 90 30
208 Angle seam end stitch count 1 - 9 5
209 Basting seam starting stitch length [0.1 mm] 10 - 60 20
210 Basting seam starting stitch count 1 - 9 3
211 Basting seam end stitch length [0.1 mm] 10 - 60 40
212 Basting seam end stitch count 1 - 9 4
213 Starting point correction, 2-point [0.1 mm] 0 – 150 120
214 Short thread trimmer confi guration
0 – not attached
1 – attached and activated
(Prog Out1 and Prog
Out2 used! )
0
215 Stacker Variant 3586 25/01 0 old, 1 new 1
300
301 NIS (carriage start) [°], see chapter 13.12.03 80 – 150 110
302 Cover thread carrier position t.d.c. [°] 70 – 90 76
303
Thread trimming position on [°]
The time at which the pulse for the thread trim-
ming is given to the thread trimming valve is
changed (° = degrees after t.d.c. needle bar).
160 – 360 200
304 Reverse rotation position [°]
0 - Cover thread car-
ried position t.d.c.
17
305 Electric clamp on [°] 100 – 185 150
306 Electric clamp off [°]
190 – 260
240
307 Position thread tension open when trimming [°] 200° – 360 250
308 Pos. elec. thread trapper on during thread cut 0° – 360° 341°
400
401 Time for blowing out [0,01s] 10 – 250 30
402 Start delay for retracting workholder bar [0,01s] 0 - 250 0
403 Fabric blowdown time [0,01s] 0 - 250 0
404 Start delay after pedal start [0,01s] 0 - 250 30
500
501 Maximum speed 200 - 4500 4500
502 Bartack speed (reduced speed) 200 - 4500 4500
503 Cutting speed (positioning speed) 100 - 250 200
504 Speed of the slow starting stitches 200 - 2000 1000
505
Slow starting stitches
The number of stitches that should be performed
at a reduced speed when sewing is changed.
0 – 99 2
506 Basting seam speed 200 - 1000 1000