Sewing
43
Target state
Infeed table forwards
10
.04
Error messages
General
The display will show a error code if a malfunction occurs. An error message is generated by
incorrect handling, malfunctions on the machine or by overload conditions. (For an explana-
tion of the error codes, see
chapter 14.02 Explanation of the error messages
.)
Error when switching outputs
If an error occurs when switching an output, the relevant output is displayed with the de-
sired switching state (
0)
or (
I
).
(
0)
means that the output should be switched off and (
I
) means that the output should be
switched on.
The cause of the error is displayed on the next line.
The target state is shown in brackets to achieve an error-free process.
The output
S5
should be activated in the following example.
Condition:
E4
must be set to (
1).
O
Check
E4
and correct the error.
O
Acknowledge the elimination of the error.
Infeed table forwards
Workholder bar up
Target state
Workholder bar up
Summary of Contents for 3519-5/01
Page 38: ...Sewing 38 Double point darts Fig 10 02 0 320 mm 0 320 mm Insertion mark Insertion mark...
Page 155: ...155 91 191 499 95 Part 7 Version 07 02 12 Circuit Diagram Overview Start 2 Start 1 Air okay...
Page 156: ...156 Circuit Diagram Overview Version 07 02 12 91 191 499 95 Part 8 A12 CAN3...
Page 157: ...157 91 191 499 95 Part 9 BDF P1 Version 07 02 12 Circuit Diagram Overview RS232 interface...