Introduction
13
Software installation
Note: the following instructions assume that the counter, PC and printer have been
connected up and switched on (see the installation instructions in the Instrument manual). If
Enhanced Security mode is used then installation can only be done by a person with System
and Windows administrator rights. See Appendix 4 for more details.
1. Load the software CD.
Load CD
2. The setup loader will start automatically and give you a choice of either selecting the
Installation Wizard to guide you through the installation or reading files from the CD.
3. When you have completed the installation you should remove the CD from the PC,
otherwise the setup loader will start again next time you boot the PC.
Note: in the case of Windows XP the user has to have “power user” rights.
Summary of Contents for Wallac 1420
